Grace's Guide To British Industrial History

Registered UK Charity (No. 1154342)

Grace's Guide is the leading source of historical information on industry and manufacturing in Britain. This web publication contains 174,149 pages of information and 250,321 images on early companies, their products and the people who designed and built them.

Grace's Guide is the leading source of historical information on industry and manufacturing in Britain. This web publication contains 147,919 pages of information and 233,587 images on early companies, their products and the people who designed and built them.

Montreal Harbour Bridge

From Graces Guide


1931 'A highway bridge of exceptional length, height and span was recently completed across the St. Lawrence, at Montreal, where the famous Victoria Bridge, rebuilt in 1898, has long served as a far from adequate link between the highways which converge on the city from both sides of the river. The Victoria bridge, being primarily intended for railway purposes, has, in fact, very limited roadway accommodation. The inadequacy of the provision for road traffic has long been felt, and has seriously hampered the development of the southern shore of the river, either for residential or manufacturing purposes. The difficulty, however, of financing a scheme of the magnitude required was such that it was not till some six years ago that the Montreal Harbour Commissioners felt justified in undertaking the work as a toll bridge, which might ultimately earn enough to meet interest and amortisation charges. ..... In January, 1925, the Harbour authority, aforesaid, commissioned Messrs. Monsarrat and Pratley, consulting engineers, of Montreal, to prepare the necessary plans and specifications, i in association with Mr. J. B. Strauss, of Chicago. .... The main span has, therefore, been given a length of 1,079 ft. between centres of piers, which, as the stream is crossed slightly on the skew, provides a fairway, normal to the current, 1,000 ft. wide between the wharf side and the masonry of the river pier. .... Silicon steel was used for all the main truss members, for the flanges of the floor beams and most of the bottom lateral systems. It was required to have an ultimate strength of 80,000 lb. to 90,000 lb. per square inch, with a yield point of 45,000 lb. per square inch, ..... This silicon steel proved to differ markedly in its characteristics from the carbon steel, and special care was necessary at the mills in order to ensure freedom from segregation. It was found essential to remove by cropping a large fraction of each ingot. The defects most commonly encountered during the subsequent working up of this material were hard spots and pipes, but thanks to the rigidity of the inspection at the steel works the total of rejections in the bridge shops was small. It was much harder on the machinery than the carbon steel, and when sheared or punched gave way with a sharp report, and the fracture was much more crystalline. Owing to these peculiarities, it was found to cost some 25 per cent. to 35 per cent. more to work up than the carbon steel. On the silicon steel, a working stress of 23,500 lb. per square inch was adopted for tension members, whilst in compression members, the permissible stress was specified to be either 19,000 lb. per square inch. ....'[1]. Continued in Engineering 1931/03/27.

See Also

Loading...

Sources of Information